Press hydraulic DE2432
Buy press DE2432 or its analog DG2432 (effort 160 tons), you can in our factory. Press DG 2432 is successfully used in the manufacture and molding of products from thermosets, rubber, sheet metal parts and plastic by compression or transfer (molding) pressing.
Press DE2432 is a press with a reliable frame form. All presses produced in our company have quality certificates, and the availability of a large range of KPO in our warehouse, allows you to get the press quickly enough, without waiting for its manufacture. Hydraulic press DE2432 is equipped with a device for adjusting the heating of the mold itself and power equipment. Press DG2432 can work in two modes: commissioning and semi-automatic. From the cycles of the hydraulic press DG 2432, it is worth noting the cycle with the ejector, the cycle with the engine cut-off at the time of holding and the cycle with the pre-presses. There is a function of heating the mold.
The hydraulic press of the model DE2432 forms products from thermosets, is used in the manufacture of large rubber products, as well as plastic and metal products, but thin. As in the model D2424, there is a heating of the mold.
Works in a semi-automatic press and setup mode. Methods of work DE2432: direct and injection molding.
Hydraulic presses ДГ2432 and ДЕ2432 are widely applied at the enterprises specializing on manufacturing of rubber and plastic for various industries. These settings differ only in technical parameters.
The design of the presses is a frame welded from a steel sheet, in the upper part of which there is a master cylinder of the plunger type. The tank and the valve are mounted on the cylinder. An air cleaner is attached to the tank cover, the central opening of the air cleaner can serve to fill the oil in the tank. In the filling tank there is a radiator for cooling the oil. The water to the radiator is fed through pipes located in the right-hand niche of the frame and taken out to the rear wall of the frame. An ejector is fixed on the bottom of the frame. The press ejector is a piston-type cylinder. In the recesses of the frame there are return cylinders, pipelines, the mechanism of the end switches of the slider. Cylinders of return, installed on the press, plunger type. The electric equipment of the press is placed in a separate press cabinet, fixed on the foundation to the right of the press frame. The hydraulic unit is fixed on the foundation to the left of the press.